门尼粘度测试

jzh2008

门尼粘度测试
Measuring Mooney Viscosity Procedure

0 v9 X+ d2 m! W- \0 v1.        选择适当的转子。Select the rotor to be used for the test.
! e: J' k" l. z" |( I! H2.        根据所测试的橡胶类型调节上下冲模的温度，两冲模间的温差不超过0.5℃。Adjust the closed dies with the rotor in place to the test temperature shown in Table 1 for the type of rubber being tested. The temperature of the two dies shall be within 0.5℃ of each other.
& |* v: |( d" z) t3.        粘度计空载启动时转矩显示置零，然后停止转盘的旋转。Adjust the torque indicator to the zero reading while the viscometer is running unloaded with the rotor in palce. Then stop the rotation of the disk.
8 N1 v$ H7 s0 r2 L6 I2 ?9 K: s( O0 ^4.        从腔膜中移开热的转子，将转子从样品中间穿过，然后放入粘度计中。把第二片试样放在转子中央，合模并激活计时器。Remove the hot rotor from the properly conditioned cavity,quickly insert the stem through the center of one of the test pieces,and replace the rotor in the viscometer.Place the second test piece on the center of the rotor,close the dies immediately,and activate the timer.
5.        在闭合的门尼粘度计中预热样品一分钟，然后启动转子马达。Warm the specimen in the closed Mooney viscometer test cavity for exactly 1 min and then start the motor which drives the rotor.
6.        根据所测试橡胶的不同类型连续记录粘度值。It is recommended that viscosity readings be continually recorded for the time shown in Table 1 for the type of rubber being tested.

xiaohu313

虽然很基础，但还是顶一个。

xingni510

有点简单，不知道怎么弄还是1

yhfzjj

没什么意思的帖子

anna_411

好，好好写下外语啊~~~

liyangfan

幸好我做过...呵呵..能看懂~~~~支持哈

liulis

我看到还不错的资料。

linshidewo

外语看不懂，学也上了，就是外语差的不得了。咱这辈子就是处于中国的

afei09

请问一下各位，德杰的门尼粘度计怎么样做硫化曲线啊